Chkconfig
The chkconfig command can also be used to activate and deactivate services. If you use the chkconfig –list command, you will see a list of system services and whether they are started (on) or stopped (off) in runlevels 0-6 (at the end of the list, you will see a section for the services managed by xinetd.
If you use chkconfig –list to query a service managed by xinetd, you will see whether the xinetd service is enabled (on) or disabled (off). For example, the following command shows that finger is enabled as an xinetd service:
finger on
More importantly, chkconfig can be used to set a service to be started (or not) in a specific runlevel. For example, to turn nscd off in runlevels 3, 4, and 5, use the command:
Leave a Reply
You must be logged in to post a comment.
